![]() ![]() The double taps should show up as doubletap button pushes. You can now use the switch like a scene controller / use the second function. Support for the hardware Double Tap Up and Double Tap Down functions implemented.I'll be happy to try and improve the driver to support those, but as I do not have any of that firmware revision, it may be slow going. If you see CRC16 messages in the log when using this driver, that means you have one of those devices. NOTE 2: The driver has not been tested on any newer firmware levels that use CRC16 for the message encoding. It should also work with the Jasco and Honeywell branded models. It has been tested with a GE 14291 switch. It will not work with the non Z-Wave Plus models (12xxx), it will not work with any dimmer model, and it will not work with the Motion Switch (26931). NOTE 1: This is for the toggle/paddle GE/Jasco Z-Wave Plus Switches only. This was derived from the ST device handler, but mostly re-written at this point as there were a number of problems with the one I started with. ![]() I got tired of the generic built-in driver missing features that are on the GE/Jasco switches. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |